http://www.partselect.com/Schematics/Whirlpool/Whirlpool_Thumb/LA6H1HC5.gif
See part 9 in the diagram

TIMER

PartSelect Number PS350126

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.2 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 3 people found this instruction helpful

Parts Used

  • TIMER

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsNutdriver, Pliers, Screw drivers

CustomerWilliam from Coral Springs FL

Washer stopped spinning after rinse cycle.

Removed the old timer and disassembled to make sure it was defective. Spin contacts were gone.
New timer worked fine, except the mounting holes had not been threaded at the factory. With mounting laundry, I chose to thread the holes myself rather than return the unit.
Washer is running fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

  • TIMER

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerBarry from Grabill IN

Tub would occasionaly not empty.

This is the second timer over the years and the original plastic know was replaced a while back with a good knob with steel insert. Fix required unplugging power cord, removal of two screws at the lower front corners of the control panel, spinning off the control knob, popping of the plastic dial, flipping up the panel, removing the two screws that hold the timer, disconnecting the two power connectors, then installing new timer in the reverse order. Note I used two smaller screws that fit the non tapped holes in the timer.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2