Timer

PartSelect Number PS350107

The timer controls most of the operations of the washer: water level, tub filling and emptying, length of cycles, and cycle setting sequences.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Timer will not advance.
  • Compare At

    $155.56
  • You Save

    $25.93
  • Your Price

    $129.63
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 3 reviews What's this?
1-3 of 3
 

8 of 8 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerMICHAEL from JASPER TX

Washing machine timer would not cycle

UNPLUG POWER THEN REMOVE TIMER DIAL COUNTER CLOCKWISE, REMOVE THE 2 PHILLIP HEAD SCREWS FROM TOP COVER REMOVE 2 SCREWS HOLDING TIMER ASSY. THE NEW TIMER ASSY MOUNTING BRACKETS HOLES[2] ARE NOT THREADED SO I USED SHEET METAL SCREWS OR YOU CAN USE SELF TAPPING SCREWS.

Help other customers find the most helpful instructions.

Were these instructions helpful?

8 of 13 people found this instruction helpful

Parts Used

  • Timer

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerCharles from Mims FL

Washing machine timer broken

The repair itself was easy. The knobs come off on the water temperature and level, you just pull them off. On the timer itself, the handle unscrews. You push the handle down and then just unscrew it. There are two screws on the front and two on the back which you remove to get access to the inside of the control panel. The timer is attached to the front of the control panel with two screws. The only thing that was unusual was that the replacement part was not identical to the original. The old timer had threads on its body. The replacement timer just had holes for self tapping screws. Fortunately, I had some self tapping screws. Installation is the reverse of removal. The most important thing to remember is to remove the electrical connector from the old timer next to the new one so you can install it exactly the same. It would probably go on backwards. Not bad for a 21 year old washing machine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

9 of 17 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers, Socket set

CustomerArthur from Seatac WA

Holes not threaded

Removing the old timer was as usual. On installing the new one, the screws holes are not threaded. Had to scrounge a self-tapping screw and run it into the holes. Also the old knob skirt prevented the new knob from pushing in. Left the knob skirt off and all is good.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3