http://www.partselect.com/Schematics/Frigidaire/Frigidaire_Thumb/V60CKUUA.gif
See part 70 in the diagram

Pump Motor Kit

PartSelect Number PS3497737

This kit includes the motor and o-rings.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

This part fixes the following symptoms:

  • Not cleaning dishes properly.
  • Noisy.
  • Leaking.
  • Will Not Start.
  • Not draining.
  • Compare At

    $134.17
  • You Save

    $22.36
  • Your Price

    $111.81
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

51 of 65 people found this instruction helpful

Parts Used

  • Pump Motor Kit

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers, Wrench(Adjustable)

CustomerJeff from Lancaster PA

Not cleaning, spray arms not working

The hardest part was disconnecting the dishwasher. the motor is located on the bottom so after pulling it out and laying it down on the front of the machine the motor unplugs and 2 screws hold it in place.The new motor comes with "O" rings so I applied a little grease and put it back together. 2 minutes to replace motor, 15 minutes to disconnect water and electric, 15 to reconnect.

Help other customers find the most helpful instructions.

Were these instructions helpful?

36 of 52 people found this instruction helpful

Parts Used

  • Pump Motor Kit

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsScrew drivers, Socket set, Wrench set

CustomerLarry from EDWARDS CO

Water leak behind kick-plate

See posting under O rings. Get schematic Motor & Pump pg. 8 from pub # 5995487674. Steps: 1) run cycle so most water is pumped out of dishwasher 2) remove front cover to reduce weight of door; 3) disconnect electric plug, hot water hose [NOTE: be prepared for some water from hose], and waste tube all usually found under sink area; 4) remove 2 screws at top of front panel; 5) lower leveling feet to allow best clearance; 6) put towels under front feet to protect floor and slide unit out from under counter; 7) place heavy blanket next to unit to protect floor and tip unit over on its side; 8) disconnect electric plug from motor and remove metal spring clip holding motor (2 torx screws) and pull clip off motor; 9)gently rock motor while lifting to remove from unit [NOTE position of motor for reassembly]; 10) put thin coat of silicon on O rings and place on new motor [look at old motor to make sure O rings are in proper slots; 11) line up motor and gently push new motor back into position; 12) reverse disassemble steps above. 13) run dishwasher through fastest cycle to check for leaks.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2