3493488-1-S-GE-WB27T11312-Oven Clock Control
3493488-1-S-GE-WB27T11312-Oven Clock Control 3493488-2-S-GE-WB27T11312-Oven Clock Control

Oven Clock Control

PartSelect Number PS3493488

NOTE: This part has been updated by the manufacturer. The wiring could be different than the original and should be installed by an appliance repair person.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $87.90
  • You Save

    $14.65
  • Your Price

    $73.25
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 2 reviews What's this?
1-2 of 2
 

9 of 15 people found this instruction helpful

Parts Used

  • Oven Clock Control

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerJohn from Gaston OR

Cooktop oil fire melted plastic parts; control defaced

Some of the original TO-9 switches were fused by the heat. I made them functional again with a cutter on a rotary tool, but to make the repair properly, I ordered the new control unit and the faceplate graphics. Note the guide tabs at the bottom and right edges when replacing the graphics. Don't plan on reusing your old graphics (unless you are a wizard at removing the very strong adhesive).
To gain access to the part, remove the 2 screws (part 715) in the bottom of the control assembly with a stubby screwdriver. Using a nut driver, remove the two screws (part 1000) on the back at the corners, being careful not to drop them behind the oven. Pull out at the bottom, then move the whole unit toward you. Note the position of the wires. A digital photo can help here. Remove the wiring and 4 screws holding the clear plastic TO-9. Put the screws in the new unit in the same holes and rewire. Put the assembly in place top-first and align the screw holes. Finding the same thread placement for the lower screws can be tricky, so start them gently.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 8 people found this instruction helpful

Parts Used

  • Oven Clock Control

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerKerry from Loveland CO

Fried oven control using raid

replaced oven clock control ref maintenance manual, 4 screws and 8 wires. plugged in new control and op checks good.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2