http://www.partselect.com/Schematics/Frigidaire/Frigidaire_Thumb/5JW4IKGS.gif
See part F20 in the diagram

Electronic Clock/Timer Control Board

PartSelect Number PS3493056

Overylay NOT included. Must order separately.

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

  • Compare At

    $154.88
  • You Save

    $25.81
  • Your Price

    $129.07
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 2 people found this instruction helpful

Parts Used

  • Electronic Clock/Timer Control Board

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerPlease Hold For from Houston TX

Due power surges clock/timer burned out could not use oven

Pulled Stove away from wall. Remove power and then back panel to access Clock/Timer. Removed Clock/Timer. Replaced Clock/Timer with new unit, and reversed removal steps. Simple simple and easy, no snags at all.
I live in Belize. There was a 3 week delay between removing the timer and installing the new one..lol. That was the only hitch. PartSelect.Com was instrumental in getting the part to a hotel in Houston where I picked up on a business trip through the U.S. Went off like clock/timer work!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 2 people found this instruction helpful

Parts Used

  • Electronic Clock/Timer Control Board

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers

CustomerJ. Fred from Patriot OH

Timer light had become dim due to the electric outages suffered from our provider

The part did not have the proper cover, it was plain. I had to remove the electric board from the old housing and the new housing and install the the new board in the old housing. Other than that it would have been a 15 minute job. I had to be very careful not to damage the old plastic housing and I was tenitive, if I broke it I would have had problems. The new part should either come with the front ID cover or it should be recommended to buy. (It looks as though it is a plastic glue on cover, but would be ruined if I tried to remove the cover from the old housing) No problems other that mentioned.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2