345730-1-S-Whirlpool-3398095           -Push-To-Start Switch
345730-1-S-Whirlpool-3398095           -Push-To-Start Switch 345730-2-S-Whirlpool-3398095           -Push-To-Start Switch 345730-3-S-Whirlpool-3398095           -Push-To-Start Switch

Push-To-Start Switch

PartSelect Number PS345730

This part is used to start the dryer once you have selected a setting on the timer.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Will Not Start.
  • Compare At

    $32.92
  • You Save

    $5.49
  • Your Price

    $27.43
In Stock
Order within the next 10 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.1 / 5.0, 3 reviews What's this?
1-3 of 3
 

76 of 84 people found this instruction helpful

Parts Used

  • Push-To-Start Switch

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerVincent from Pipersville PA

Defective switch

unplug dryer
pull off switch knob
remove two screws at corners of control unit
pull unit toward you to remove
flip over and remove panel
unscrew switch then twist switch to remove from face on control unit
holding new switch next to old, remove wires from old switch and insert onto new switch
place new switch on control unit face and twist into position
Install screws
replace panel, flip back over
position control unit and slide back to lock in place
screw in corners
replace switch knob
plug in dryer
test switch

Help other customers find the most helpful instructions.

Were these instructions helpful?

13 of 14 people found this instruction helpful

Parts Used

  • Push-To-Start Switch

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsPliers, Screw drivers, Socket set

CustomerAnna from Spring Hill FL

Dryer would not start

It was as easy as 123 took off old part reconnected the wires put the srews on put the cover back and my dryer is working like new again thank you PartSelect for making my life a little easyer Anna Lavergne

Help other customers find the most helpful instructions.

Were these instructions helpful?

7 of 21 people found this instruction helpful

Parts Used

  • Push-To-Start Switch

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerRobert from Largo FL

Replace bad timer

opened the back of the control panel, removed the timer. Looked for damage, saw none but replaced because it was not working. The wirers did not match up extact. But enough matched the wire and terminal code that the two left attached to the two remaining. After it was plugged back in and tryed it worked!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3