| |
11 of 26 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerKEVIN from PLAINFIELD IL
Soap dispenser door/spring broken
removed old parts and re-installed new parts. The spring is a little hard to get to the right point without a jewelers screwdriver, after that everything worked fine.
|
4 of 6 people found this instruction helpful
Parts Used
Level of DifficultyVery Difficult
Time to do repair:1- 2 hours
ToolsScrew drivers
Customergeorge from ten mile TN
Soap door on dishwasher broken
Got the new door and tried to put it on. The door went on very easily. However, there's a spring that opens the door when the main wash cycle comes around. I never did get that spring right. None of the drawings showed the correct position and after an hour of trying to get it to work right, I gave up. The door comes open slightly (but not because of the spring) when it's time, and the liquid soap runs out due to gravity. But I wouldn't try to use soap powder because the door doesn't come open far enough.
|
4 of 10 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerEmile from Jamaica NY
Inserting lid spring
Had to be careful positioning the spring without breaking the hinge pin. Requires a certain amount of patience.
|
2 of 5 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
Tools
Customered from potomac MD
The soap dispenser lid was broken
I ordered a dishwasher soap dispenser "lid assembly". When it arrived, it was not an assembly at all but only a lid. I had to reorder a pin and spring, When i finally had every thing, it was an easy repair.
|
0 of 3 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:Less than 15 mins
Tools
CustomerBob from Carlsbad CA
The detergent door won't open fully
Sorry, probably need a spring as the door is fine. While reading other stories about how hard the spring was to get right, I assumed the spring was part of the door assembly.
I'll be calling and returnint the part.
i'
|
0 of 4 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerD from Sadieville KY
Will not dispense soap
Remove old spring pin, spring, door
Waste of time effort and money didn't change a thing still won't dispense soap to wash dishes
|
1 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerRobert from Port Clinton OH
Soap lid pin broken
Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.
|
4 of 19 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerJim from Oktaha OK
Soap lid missing
Replacing the pin with the spring is a little tricky, it was hard to hold it. And the little plastic pin breaks real easy too, its hard to get the lid to snap in place without breaking the pin.
|