| |
14 of 19 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerHAROLD from FISHERSVILLE VA
Worn out spring on detergent release box lid
First, examine very carefully how the old spring relates to the detergent release box lid. Note that the top of the spring has a square-end upside down "U" . This rests on a small ledge on the detergent box. Also note that on either end of the spring is a straight extension of the spring wire. These two "legs" must rest on the inside of the edge of the detergent box. Second, use a flat blade screw driver to pry the LID hinge pin from the mounting "posts. Remove the pin, first noting the position of the spring. Reassemble the spring on the hinge pin in reverse order. Then snap the lid onto the spring using the two mounting "posts". NOTE: I used a very fine needle nose pliers to move the two spring "legs" behind the detergent box edge after I had mounted the lid. Flip the lid down to test if the spring pressure on the lid can be felt. Harold Kitzmann, Fishersville VA
|
4 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJo-Anne from Columbia SC
The pin was broken
but the pin in and add the pin though the 2 tabs close door on it open it up move the springs backwards to the door
|
10 of 25 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerKEVIN from PLAINFIELD IL
Soap dispenser door/spring broken
removed old parts and re-installed new parts. The spring is a little hard to get to the right point without a jewelers screwdriver, after that everything worked fine.
|
4 of 10 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerEmile from Jamaica NY
Inserting lid spring
Had to be careful positioning the spring without breaking the hinge pin. Requires a certain amount of patience.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers
Customerdwight from onaka SD
I broke one part trying to install
no tools necessary buy instructions would have brrn helpful
|
0 of 4 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers
CustomerD from Sadieville KY
Will not dispense soap
Remove old spring pin, spring, door
Waste of time effort and money didn't change a thing still won't dispense soap to wash dishes
|
1 of 7 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers
CustomerRobert from Port Clinton OH
Soap lid pin broken
Snap the old lid off, remove the pin & spring & install new Pin & Spring. Very easy. Thanks To Parts Select got the right parts.
|
4 of 19 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerJim from Oktaha OK
Soap lid missing
Replacing the pin with the spring is a little tricky, it was hard to hold it. And the little plastic pin breaks real easy too, its hard to get the lid to snap in place without breaking the pin.
|