| |
8 of 9 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerAL from TINLEY PARK IL
Element started sparking and caught on fire
turned off breaker for oven,opened door, removed racks,removed two screws,pulled out the element, dis connected wires,reconnected new element,put back screws,replaced racks,turned breaker on,perfect fit.
|
2 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJack from Seward NE
Bottom oven would not heat
When I removed the bottom bake element and tested it with an ohm meter, it was an open circuit. Once the new one arrived, I simply had to hook up the two leads, screw the cover back on the back of the oven and the job was done.
|
2 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsPliers, Screw drivers
CustomerRalth from Fairview TX
The element, bake . Broke when particure flamely split .
when I removed the element I notice that the terminal of the two wires they were verticale and the old part were about 15 degree upright, so I used player to bend the angle. it is working .Also let me say Part Select has wanderful service by phone and fast deliver.
|
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerTerry from Bedminster NJ
Bake element failed
Removed 2 screws securing bake element, pulled element clear with wires still attached, then removed the wire push terminals. Attached terminals to new bake element and reinstalled. Extremely simple.
|
2 of 4 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerPaul from Woodward IA
Bake element weakened in one spot and burned through
I removed two screws holding the element in place. Carefully pulled the element from its mounting throught insulation to expose the two wires connected by electric wire clips. I removed the clips and searched the part online using google. Part Select was provided as the top source. I ordered the part and it was delivered in two days. Taking care to thread the connection through the insulation, I was pleased to have installed it in about 5 minutes. All tools were still out and ready for use. Thank you for your service
|