| |
3 of 7 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsScrew drivers, Socket set
CustomerRussell from Chicago IL
Out of ballance
removed two phillips screws from control panel. lifted panel to reveal two clips on both sides of machine. used flathead screwdriver to remove clips. tilted whole body up and away. pushed drum towards first spring and removed it . installation was reverse of procedure. did not fix it because basket had rusted at shaft bottom under agitator and put basket out of balance.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerMorris from Tampa FL
Cold and hot water function did not work.
I first unplugged the power.Then I turned off the water supply and disconnected the water hoses from the unit.Afterwards,I unscrewed and opened the back panel.I then removed and replaced ordered parts.I reinstalled the back panel and hoses.I turned on the water supply and plug in the power cord.I tested the cold and hot water functions and it worked like a charm.
|