| |
4 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerCarrie from Waukesha WI
Spring latch broke and bowl would wabble around when the mixer was on
I unscrewed the spring latch (I could not find a screw driver- so I used a butter knife) I took the new one and screwed it on........the total time took about 2 minutes!
The best news was that the parts were delivered in 2 days after ordering!!!!!!!!! Amazing!!!!!!!!!!
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJOAN from CARBONDALE IL
Spring clip broke off
As I was using my mixer the spring clip broke off. I immediately went to my computer and googled you. Twenty-four hours later the part had arrived and I installed it by removing two screws, holding the spring in place and replacing the screws. At the same time a repairman was in our home repairing our drier and I felt so empowered by my repairmanship that I nearly asked him to leave!
Thanks for your extreme promptness and readable parts chart.
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerBernadette from Hackensack MN
Bowl spring broke in two pieces
Removed the two screws that hold the bowl spring in place. Removed broken spring. Replaced broken spring with replacement spring. Tightened two screws that hold it in place.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
Customerjohn from North Kingstown RI
Spring latch on kitchenaid broke
Two flat head screws removed, swapped out the latch, and replaced.
The entire repair took about two minutes.
Price was acceptable given the worth of the mixer.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerJeffrey from Deep River CT
Spring latch broke (it is 30 years old)
checked online for the part name, called and ordered the spring latch. It came in a couple days and works fine. Many thanks.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerCorreen from Jaffrey NH
Broken spring latch
Easy off-easy on! Parts were exactly what I needed.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerRandy from Ingram TX
Spring latch broken
Take off the old one, put on the new one--start kneadin' bread. Finding a screw driver was the hard part.
|