337177-1-S-Whirlpool-3169258           -Electronic Clock & Oven Control Assembly
337177-1-S-Whirlpool-3169258           -Electronic Clock & Oven Control Assembly 337177-2-S-Whirlpool-3169258           -Electronic Clock & Oven Control Assembly

Electronic Clock & Oven Control Assembly

PartSelect Number PS337177

This part controls most of the functions of your oven.

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

17 of 25 people found this instruction helpful

Parts Used

  • Electronic Clock & Oven Control Assembly

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerCarmela from Tuckahoe NY

Oven display error f1 oven not functioning

Secured circut breaker for range and began to remove rear panel w/screw driver. Revealed and removd 2 screws that secured existing control assembly. Installed new in kind and secured, then began very gently unplugging and reconnecting old to new. Task was done very slowing to insure that plugs were fastened correctly. When complete, energized breaker and all was functioning, secure breaker again and completed reinstallation of back panel. Energized breaker, adjusted clock, testing and all was functioning back to normal. Job Complete. THANK YOU!

Help other customers find the most helpful instructions.

Were these instructions helpful?

9 of 14 people found this instruction helpful

Parts Used

  • Electronic Clock & Oven Control Assembly

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers

Customermark from bellevue OH

Control asm failed;intermitent oven op.

Turn off power to range at circuit breaker!!!!!!!
(exposed connections on back of control asm,
will result in electrical shock!!!)

slide unit out approx. 6" to expose all screws
holding face panel in place. Remove all
screws holding face panel and remove panel.

Remove all electrical connectors from ctrl. asm.
and two retaining screws holding ctrl. asm.

Install new control asm. and reverse procedure.

Piece of cake!!

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2