http://www.partselect.com/Schematics/Whirlpool/Whirlpool_Thumb/R4CSJSTT.gif
See part 28 in the diagram

Water Filter Housing

PartSelect Number PS330080

This part works with the following brands: Whirlpool, Admiral, Estate, Inglis, Kenmore, KitchenAid, Roper, Maytag, Crosley, Jenn-Air, Hardwick, Magic Chef, Amana, Caloric & Glenwood.

This part fixes the following symptoms:

  • Leaking water.
  • Compare At

    $87.77
  • You Save

    $14.63
  • Your Price

    $73.14
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 1 reviews What's this?
1-1 of 1
 

20 of 27 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:1- 2 hours

ToolsNutdriver, Screw drivers, Wrench set

CustomerJohn from Germantown TN

Persistent leaks in the water/ice making supply system

My attempt to repair a leak in the water supply lines merely generated other leaks. It became obvious that the whole supply and filtration system should be replaced. 1. Turn off water supply and unplug the refrigerator. 2. Remove the fiber cover from the lower rear of the refrigerator. 3. Disconnect nylon supply tubing at the supply spigot and at the water valve near the rear of the refrigerator. Both of these tubes connect to the filter housing. 4. Remove the grille at the front of the refrigerator under door. 5. Removing the front grille gives access to the front of the filter housing Remove the two screws holding the filter housing in place. 6. Remove the filter housing with both nylon water tubes as an assembly. Some coaxing may be necessary, because there is no clearance between the bottom of the refrigerator and the front cross-member. Rotate the assembly about 1/4 turn clockwise as the assembly is withdrawn. 7. Install the new tubes into the new filter housing. 8. Install the assembly into the front of the refrigerator, reversing the removal procedure. 9. Either remove the old filter from the old housing and install it in the new housing or replace the filter. 9. Turn on the water and check for leaks. While the refrigerator is open, use this opportunity to clean the condensor coils. 10. If there are no leaks, replace the front grille and the fiber cover on the back of the refrigerator. 11. Turn on the power.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1