Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS306956
This part works with the following brands: GE, Hotpoint & Kenmore.
moved refrigerator away from wall and unplug it from electric outlet, turn water supply to the Water Valve off, removed 4 screws that hold refrigerator back cover, move cover out and removed water supply line from valve, removed 1 screw that hold the Outlet Water Valve and remove it slowly until you can disconnect electric wires. Cut plastic water lines with box cutter or cutting tool at the valve. To install push water lines into new valve, they will selfsecure, each one is different size and there will be no confusing which one go where, if electric plugs are diferent, adapter are provided, just plug them in and the plug in electric wires and then reverse the the order of disasembly to finish. (hint, before installing back cover check for leaks). the slide rails are very easy to replace, just remove the old one with a cross tip screwdriver and replace. actuator pad was very easy to replace, pull old one out and push new one in place.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed 2 Phillips head screws and replaced rail. Glass cover does not fit on rails perfectly, but solved the problem.
Removed 2 screws on each slide, Screwed in new slide. Done! The hard part was picking the correct part #. Ordered the wrong parts. Parts Select representative helped me get the correct part # and assisted with the return. Thanks.
Really easy. I am the type that measures once and cuts twice! But this time even I could do it. The hardest thing for me was locating a phillips head screwdriver in the house. I ordered the correct parts, thanks to the diagram provided, and followed the easy directions. It went exactly as expected.
Remove and replace two phillips head screws. Finished! Why didn't I do this years ago. It took longer to clean out the vegie crisper than it did to replace the slide rail.
I removed the two Phillip's screws holding the old slide and removed it from the compartment. I placed screw into back mounting hole and partially tighten. Next I swung the slide up till the front hole matched the hole in compartment wall and installed this screw. I tightened both screws and returned the drawer to the refrigerator.
First of all, the Parts Select response was extremely quick. Would order parts from them every time. The installation was removing two screws and broken part while replacing with the new one. Quick easy no problem.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.