300598-1-S-GE-WR32X10146        -Meat Pan Cover Front
300598-1-S-GE-WR32X10146        -Meat Pan Cover Front 300598-2-S-GE-WR32X10146        -Meat Pan Cover Front

Meat Pan Cover Front

PartSelect Number PS300598

This piece is located on the front of the meat pan cover.

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $49.99
  • You Save

    $8.33
  • Your Price

    $41.66
In Stock
Order within the next 12 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

3 of 5 people found this instruction helpful

Parts Used

  • Meat Pan Cover Front

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

Customerdavid from penn valley PA

Meat drawer broke

the replacement part did not have the 3 screw holes needed to 100% replace the part that broke. however, i realized that the piece that fastens to these 3 screws is the slider cover piece (i dont know its name) that has the rubber gasket was sticking every time i opened the drawer and this was what caused the OEM part to break. anyone who has a GE profile with the meat compartment must know what i am talking about - it sticks and is a bit clunky to open (until the pressure breaks the pin holding the gasket as in my case).
i simply did not place that piece back when i put the replacement part in, and now it slides much more easily. the downside is slightly less seal for the meat compartment, but to me that isnt very important because that compartment does not need to be isolated from the rest of the fridge to do its job.

Help other customers find the most helpful instructions.

Were these instructions helpful?

3 of 6 people found this instruction helpful

Parts Used

  • Meat Pan Cover Front

Level of DifficultyEasy

Time to do repair:Less than 15 mins

Tools

Customercarlos from freeport NY

Original part broke (weak design)

replacement part was not identical to the original. Mounting screw sockets did not exist on replacement part. I still used the new part but it is held in place by gravity (no screws). New part works but must be treated gently or will break like the original or fall out of place. Part diagrams online were not adequately clear. It would have been good if photos existed of the replacement from assorted angles, and I would have seen the lack of mounting screw sockets.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 4 people found this instruction helpful

Parts Used

  • Meat Pan Cover Front

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerGreg from Bakersfield CA

Broken hinge clip

After receiving the replacement part, I was a little concerned. The replacement part was not a mirror image of the original, though, after reading and following the instructions, replacement went fairly well. Conclusion: even though the replacement part was not exactly the same, it was a lot less complicated. compared to the original.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3