Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/GE/00002746i02.gif
See part 608 in the diagram
http://www.partselect.com/Schematics/GE/00002746i02.gif

Light Switch - 3 Terminal

PartSelect Number PS296357

This part works with the following brands: GE, Hotpoint & Kenmore.

Compare At

$63.26

You Save

$10.54

Your Price

$52.72
Order within the next 8 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 2 reviews What's this?
1-2 of 2
 

2 of 3 people found this instruction helpful

Parts Used:
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Richard from Kalama, WA

Both light switches bad and crisper rail broken

It was REALLY EASY to ID the parts with your website. I found exactly the rail I needed, and it recommended I buy the other rail as well. Since they were both 15 years old, that sounded like a good idea. The rails installed in about 10 minutes total. Two screws on each rail.
The door switches were more challenging, but it was because there was a lot of sticky soda on our old door switch, making me think it somehow needed other tools to remove it. No, just patience and effort. Once I removed all sticky stuff from the old switch, it pried out with a flat head screwdriver, the wire plugs came right off, and plugged in the new one. 10 minutes to get the old part out, 1 minute to put the new part in!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

0 of 1 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers, Wrench (Adjustable)
Customer: William from Austin, TX

Light out in freezer. Water valve inoperative.

Light switch- Removed old switch light using flat head screwdriver, removed wiring harness, attached new switch and reinstalled.
Water Valve- Removed dust panel, removed old valve, including water inlet and outlets (2) and remove wiring harness. switch water inlet line from old switched to new. Installed wiring harness on new valve. Had to drill pilot hole in refrigerator cabinet to match new frame holding water valve. Installed valve, reconnected water outlets (2). reinstalled dust cover.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2