Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS293459
This plastic water tube comes with the water dispenser spout.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
First Remove the screw and cover from the left top front of the fridge using a Phillips Screw Driver # 2Then using a nut driver 1/4 of inch (or Socket set)remove the two nuts holding the door hinge keeping the door in closed position. Now unplug the electrical connector between the door and the fridge body(Simply pulling it apart) Now hold the door from the middle and raise it up so that it can slide out from the bottom hole, on the main bodyNow place the door on a table or a flat surface(Put may be a sheet or some thing to prevent the finish from getting scratched) Now remove the nuts around the inner panel of the door(nut Driver or Socket set) Remove the old lining and discard .Install the new lines and then replace every thing in the reverse order. Note : Before tighting the top nuts of the door, make sure you keep the door aligened so you would not have to do it after completeing the job.
Help other customers find the most helpful instructions.
Were these instructions helpful?
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.