| |
4 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerGeorge from Louisville KY
Plastic light sheild over freezer light had broken.
Removed old sheild and reached in freezer replacing sheild with screwdriver. 3 - 4 minutes.
Ordered sheild online one afternoon and received the nest afternoon. Great transaction. will use again when needed.
George in Louisville, KY
|
4 of 6 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:1- 2 hours
ToolsScrew drivers, Socket set
CustomerSarah from Burton MI
Freezer would not auto defrost. Food side would be warm.
Your customer installation comments were very helpful. After unplugging the unit, I took out all the freezer shelfs and the back panel (4 screws). I hadn't realized the coils were also covered in solid ice. It took awhile to defrost with a hair dryer, and I needed to use more than one towel to soak up the melting ice. Locating and splicing in the new thermostat was very easy. I used "cold weather" electrical tape to splice the wires back together. After reassembling the back panel and shelfs, I snapped in a new light shield that had been broken for awhile. It's been over a week now, and I do not see any problems. Overall, it was a easy fix. Just took a little time to defrost the coils.
Sarah
|
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver, Screw drivers
CustomerRobert from Dos Palos CA
Refrigerator control temp was not working, needed shield for freezer
Removed the screws, replaced element, then replaced, shield in freezer, was really simple.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsNutdriver, Screw drivers
CustomerJohn from Aylett VA
Refrigerator was icing up.
The repair was straight forward:1. remove all food 2.remove the inside cover over the coils 3. defrost the coils and kill the power 4. remove old heater. 5. reroute wires 6. install new heater 7. assure heater worked by putting frig in defrost cycle 8 Reassemble.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerMaxie from Omaha NE
Broken freezer light shield
I was amazed the part arrived the next day the installation was simple.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyVery Difficult
Time to do repair:More than 2 hours
Tools
CustomerLila from Tamarac FL
Cannot find where the notches are in the freezer
|