Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS292255
This part helps to contain parts for the ice and water dispenser. The overlay and dispenser board is attached on the front of the housing shield.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
I carefully removed the trim from around the dispenser area then freed the catches in the top of the electronic card. I leaned the card forward and disconnected the electrical connections, then removed the card. I removed the four screws holding the shield to the door and removed the shield. Then I removed the funnel from the shield and removed the spring from the old funnel and placed it on the new one. I removed the light and socket from the old shield and installed the in the new one, then installed the new funnel on the new shield, used the four screws to install the assembly on the door and replaced the trim piece.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Unplugged power cord. Used a small screw driver to release the bottom of the control panel. Pulled it out and unplugged wires, then set it aside. Removed 4 screws from the housing shield and pulled it out. Now the solenoid assembly and related parts are accessable. I removed the solenoid assembly by loosening the top screw and removing the 2 bottom screws. This was the main problem, but I also replaced related parts that were worn or corroded. I also cleaned and disinfected everything in there while I had it apart because it was pretty nasty! Now it works like new.
Pull plastic trim piece off refridgerator door,unclip printed circuit board and remove wires unscrew dispenser housing,and remove. Transfer Ice funnel to new dispenser housing with old spring. Reinstall dispenser housing and printed circuit board.
Took the trim piece off, took 4 screws out & replaced the part. Problem solved!
I replaced that part, but I still have the same problem, no water is dispensed. I believe I may need a circuit board. The problem was not the parts I replaced.
Removed the plastic frame by pushing to the inside (all 4 sides), removed touch pad by sliding it to my right and disconnected the wires. Removed the four screws that hold the dispensing unit and replaced broken parts. Please note that I also replaced the funnel. Total cost of repair for DIY $30.00, savings by avoiding repair man, priceless.
Replaced parts by removing four screws. Old parts were damaged from overheating with a hair dryer because the water line was frozen.
simply removed the parts, and replaced the new parts and disconnected the light switch so it only comes on when using the dispenser and goes off by it's self.
The trim, funnel and housing were removed. I exchanged the small electrical part to the new housing and reinstalled the housing, funnel and trim. It took longer to get the tool then it took to make the repair.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.