Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS291937
This part works with the following brands: GE, Hotpoint & Kenmore.
Pull plastic trim piece off refridgerator door,unclip printed circuit board and remove wires unscrew dispenser housing,and remove. Transfer Ice funnel to new dispenser housing with old spring. Reinstall dispenser housing and printed circuit board.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed the bottom front cover, under the two doors, unclipped the water line to have better access, removed old Union connector, cut about a 1/4' off each side of the line, pushed both sides of line in Union Connector, checked for leaks, all done.
Replaced the motor that drives to sprial that moves the ice to the door. Remove ice tray and top cover, umplug wires from motor frame, remove three nut screws that hold the freme in place, remove three nut screws that hold the motor in place, remove plactic motor cover. Install back the same as taken off. Took less then twenty minutes. Easy to repair.
Just look at the parts diagram and follow the explanation. That easy. Still not dispensing water, so i think i need a switch since the water filter is new but no water.
put the new one in the door
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.