| |
3 of 8 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerDavid from Billings MT
Melted dispenser housing shield with hair dryer trying to thaw out frozen water line
Pull plastic trim piece off refridgerator door,unclip printed circuit board and remove wires unscrew dispenser housing,and remove. Transfer Ice funnel to new dispenser housing with old spring. Reinstall dispenser housing and printed circuit board.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerSharon from Louisville KY
Tried to wash it in the dishwasher, fell through, and "cooked"
put the new one in the door
|
2 of 7 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerRonald from Forestburg TX
Ice would not come out of door
Replaced the motor that drives to sprial that moves the ice to the door. Remove ice tray and top cover, umplug wires from motor frame, remove three nut screws that hold the freme in place, remove three nut screws that hold the motor in place, remove plactic motor cover. Install back the same as taken off. Took less then twenty minutes. Easy to repair.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:Less than 15 mins
Tools
CustomerNaz from Rocklin CA
Plastic water line leaking
Removed the bottom front cover, under the two doors, unclipped the water line to have better access, removed old Union connector, cut about a 1/4' off each side of the line, pushed both sides of line in Union Connector, checked for leaks, all done.
|