Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS285013
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Pulled the front panel off and let it hang by the wires, removed 4 screws replaced the new funnel ice display and spring works great.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I followed the video that was posted in the section. It was very helpful. I wasn't sure on how to remove the panel and the video explained it completely.
The repair was fairly simple. I unscrewed all of the screws holding the inside door panel from the outside door panel. I then removed the old (broken) door actuator with the new one, and then screwed everything back together. I used the exploded drawing of the dishwasher from the PartSelect website which helped considerably, and also don't forget to put the spring on the actuator before you install the new one. If your door actuator broke, then you should by the spring that attaches to it, because you have about a 1% chance of finding the new one.
I removed the face plate (ice/water, selection panel) from the freezer door to access and remove the solenoid which was badly rusted and replaced with a new one, and a new spring too. Very simple repair for a chronic pain.
After finally getting the door open and opening it up, the problem became apparent. Partselect helped me locate the part. it came quickly, and the repair was simple. It took me two trys to discover how the spring fit, but once I looked closely at the diagram, it was a cinch. I was a very proud dishwasher owner!
order the flopper, spring and racker can`t replace them; becouse factory recall back on 2003 most replace two ft. door of refrigerator. for $400.00
Two years ago the same problem cost us $160.00 to replace the same two parts. The latch failed in the exact same location and I'm disappointed that GE hasn't redesigned the latch to eliminate the sharp 90 degree angle at the point of failure. I purchased two sets of parts for $35.00 and replaced them with some small effort and little risk. I still have a set of parts for the next time it fails. It sure beats calling an authorized GE repairman and paying $160.00 or possibly more .
opened door removed screws holding back side of door took out front panel with latch assembley found broken part and replaced it
Removed inner panel, replaced failed parts, replaced panel.Thanks for your fast shipping response. Parts were ordered on Sunday night, you shipped Monday, I got them Tuesday !Outstanding.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.