273876-1-S-GE-WH8X281           -Lower Shaft Seal
273876-1-S-GE-WH8X281           -Lower Shaft Seal 273876-2-S-GE-WH8X281           -Lower Shaft Seal 273876-3-S-GE-WH8X281           -Lower Shaft Seal

Lower Shaft Seal

PartSelect Number PS273876

This seal goes to bottom of the transmission to stop oil from leaking at the bottom of the appliance.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Leaking.
  • Compare At

    $20.83
  • You Save

    $3.47
  • Your Price

    $17.36
In Stock
Order within the next 3 hrs and your part ships today!
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.8 / 5.0, 2 reviews What's this?
1-2 of 2
 

17 of 19 people found this instruction helpful

Parts Used

  • Lower Shaft Seal

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsScrew drivers, Socket set, Wrench set

Customeropal from richmond KS

Lost all gear oil bottom of transmission

put washer on its side,removed 1cross section,loosened the nut that held on the pulley.
loosened the motor and removed drive belt,removed drive pulley,removed old seal,poured in 90 weight gear oil,installed new seal and done everything else in reverse order.
stood washer upright connected water hoeses,waste water discharge hose,set washer to spinanr turned it on to make sure no more leaks.
everything is working well

Help other customers find the most helpful instructions.

Were these instructions helpful?

13 of 15 people found this instruction helpful

Parts Used

  • Lower Shaft Seal

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsSocket set, Wrench set

CustomerThomas from Lee's Summit MO

Oil coming out of machine, pulley was throwing it everwhere

took motor lose and belt lose first, then took pulley off from the tub shaft, then made a big mistake, I took and pulled the lower shaft seal. lucky I had a pan to catch the oil about half a gallon. After that I could not find away to put oil in the gear box, so I took the drum out and that didn't work but it was a good thing I did because the inside drum was rusting so I spend money on the seal for nothing. Had to buy a new washer. If I ever did it again I would turn the whole washer up side down so the oil could not run out and I would put the oil in the hole where the seal was. lot of work for nothing.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2