BBB A-Plus
271127-1-M-GE-WH1X2757-Timer-Knob-with-Clip.jpg
271127-1-S-GE-WH1X2757-Timer-Knob-with-Clip.jpg 271127-2-S-GE-WH1X2757-Timer-Knob-with-Clip.jpg 271127-3-S-GE-WH1X2757-Timer-Knob-with-Clip.jpg

Timer Knob with Clip

PartSelect Number PS271127

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Timer will not advance
In Stock

  • Compare At

    $14.72

  • You Save

    $2.45

  • Your Price

    $12.27
Fast Shipping

Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions

Provided by PartSelect customers like you.

< PREVIOUS 1 NEXT > 1-5 of 5

 

11 of 13 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:Less than 15 mins

ToolsScrew drivers

CustomerClifford from Sun Valley NV

Teeth on timer knob broke off

Removed timer knob clip and installed new dial and timer knob

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 3 people found this instruction helpful

Parts Used

    • Timer Knob with Clip

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerLori from Manchester VT

Washer knob was broken

simply replaced the old knob with the new one.

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 1 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsPliers

CustomerKristine M from Yardley PA

Agitator won't work wash cycle spins okay

Getting the agitator out was the biggest hurdle. It was good to have the info from others that had the same problem. I ended up using a nylon strap with a buckle(used on a suitcase when you travel)and putting it under the bottom of the agitator and using a two by four as a lever. Leaning on it and even putting most of my weight on it didn't do it. Finally I took a rubber sledge hammer and pounded the end of the board three or four times and it popped off. Replacing the coupling was a piece of cake, as was puttting it back together. Unfortunately when I ran the cycle it still didn't agitate (88% chance coupling was the prob) So next I took the front off and checked the belt ...... it was fine. Probably the clutch or the motor ...... washer is too old to pay to have either of those replace. I replaced the dial (since I had the part anyway) It also was very difficult to pry off and I broke the plastic ring in the process ........

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 2 people found this instruction helpful

Parts Used

    • Timer Knob with Clip

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsPliers

Customerwilliam from millen GA

Teeth worn off of knob

removed old knob pushed on new nrw one locked on wifh key

Help other customers find the most helpful instructions.

Were these instructions helpful?

0 of 3 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

Tools

CustomerJAMES from Boca Raton FL

Timer knob defective

After viewing the brief video supplied by you,it was a simple five minute fix.

Help other customers find the most helpful instructions.

Were these instructions helpful?

< PREVIOUS 1 NEXT > 1-5 of 5