Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS271127
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Removed timer knob clip and installed new dial and timer knob
Help other customers find the most helpful instructions.
Were these instructions helpful?
I went to your web suite to get part numbers. Found your videos. It told me what my problem was and how to fix it. Pull clip off. install new knob reinstall clip done. Very easy and fast. I couldn't even get a repairman out that fast.
had to pull knob out to see the clip locking the knob to the post.finally got the clip out, pulled knob off sand put on new knob with new clip
After pulling the knob out ( on position) a white retainer clip was visible behind the knob. Using a paper clip bent in to a "J" shape I was able to easily remove the retainer clip and knob . The old knob had several stripped teeth that caused the problem. The new knob came with the retainer clip installed . The knob slipped on and locked in position.
repair was quick and part came quickly. I was very satisfied.
After viewing the brief video supplied by you,it was a simple five minute fix.
simply replaced the old knob with the new one.
removed old knob pushed on new nrw one locked on wifh key
Getting the agitator out was the biggest hurdle. It was good to have the info from others that had the same problem. I ended up using a nylon strap with a buckle(used on a suitcase when you travel)and putting it under the bottom of the agitator and using a two by four as a lever. Leaning on it and even putting most of my weight on it didn't do it. Finally I took a rubber sledge hammer and pounded the end of the board three or four times and it popped off. Replacing the coupling was a piece of cake, as was puttting it back together. Unfortunately when I ran the cycle it still didn't agitate (88% chance coupling was the prob) So next I took the front off and checked the belt ...... it was fine. Probably the clutch or the motor ...... washer is too old to pay to have either of those replace. I replaced the dial (since I had the part anyway) It also was very difficult to pry off and I broke the plastic ring in the process ........
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2016 , Eldis Group Partnership. All rights reserved.