9 of 19 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
CustomerJeff from Blacklick OH
Needed to replace a rusted washer lid
All the parts were delivered in 3 days, every part fit perfectly.
The on line parts service person was very helpful.
We saved hundreds of dollars!
3 of 7 people found this instruction helpful
Level of DifficultyA Bit Difficult
Time to do repair:More than 2 hours
ToolsNutdriver, Screw drivers, Socket set, Wrench set
CustomerMichael from Ballwin MO
Unit would not agitate or spin
I checked the motor,it was bad I was pulling to 20 amps too much. The washer was still not working and the motor was bad so I checked the lid switch for continuity. The switch was a magnet type so with the lid down you should have continuity. In other words, a closed circuit. When the lid is opened, you should have a open circuit, Which would show no continuity. An open circuit means a break in the circuit. To change hinge bushings, raise lid, remove the screws on the outside of the lid, remove hinge, remove lid, insert new hinge bushings, place hinge through lid into bushings, and then put the screws back into the lid. If you followed these steps you should be done.