271111-1-M-GE-WH1X2741-Hinge-Bushing.jpg
271111-1-S-GE-WH1X2741-Hinge-Bushing.jpg 271111-2-S-GE-WH1X2741-Hinge-Bushing.jpg 271111-3-S-GE-WH1X2741-Hinge-Bushing.jpg

Hinge Bushing

PartSelect Number PS271111

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $4.27
  • You Save

    $.71
  • Your Price

    $3.56
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.0 / 5.0, 1 reviews What's this?
1-1 of 1
 

3 of 6 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:More than 2 hours

ToolsNutdriver, Screw drivers, Socket set, Wrench set

CustomerMichael from Ballwin MO

Unit would not agitate or spin

I checked the motor,it was bad I was pulling to 20 amps too much. The washer was still not working and the motor was bad so I checked the lid switch for continuity. The switch was a magnet type so with the lid down you should have continuity. In other words, a closed circuit. When the lid is opened, you should have a open circuit, Which would show no continuity. An open circuit means a break in the circuit. To change hinge bushings, raise lid, remove the screws on the outside of the lid, remove hinge, remove lid, insert new hinge bushings, place hinge through lid into bushings, and then put the screws back into the lid. If you followed these steps you should be done.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1