1 of 3 people found this instruction helpful
Level of DifficultyReally easy
Time to do repair:30 - 60 mins
ToolsPliers, Screw drivers
CustomerTimothy from Richmond VA
A load imbalance caused one of the four yokes to break in two.
I had to tilt the machine to gain access to the screw that holds the yoke bracket in place. Then I removed the one screw that holds the yoke bracket and removed the yoke and it's cushion. I then had to remove the two friction pads from the old yoke and install them on the new yoke. I was able to re-use the old yoke cushion and after re-assembling the yoke and cushion, I installed this assembly with the one screw. Righted the machine and the job was done.