1 of 3 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers, Socket set
Customer: GLEN from NORWICH, CT
Washer wouldnt run right
Removed the timer nobs on front and the smaller nob was broken , took the back off the control panel removed screws disconnected wiring harness pulled out timmer . Replaced those parts , the drain hose on the back took the 2 screws out puled the old hose out and installed new one the washer runs perfect thank you much glen haskell
1 of 4 people found this instruction helpful
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers
Customer: Thomas from Crossville, TN
Washer would not shut down in rinse cycle.
Removed 4 screws from top of washer panel.
Removed plastic locking pin on control knob. Removed control knob. Removed one screw that holds timer in place.
Reversed what I did to reassemble .