Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS268240
This dryer timer is used to control the unit's cycles by regulating the length of time that power is directed to each setting.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Removed two torx screws from the control panel. Removed timer with socket wrench and disconnected socketed electricals. Everything went slick.
Help other customers find the most helpful instructions.
Were these instructions helpful?
I got the parts & a friend did the repair. He removed the "cover" from the top of the dryer to install the new timer. He "plugged" it back in, put the cover back with the screw driver & replaced the knobs & the dryer was good to go. It was much easier than I thought it would be. Getting the parts from you guys was awesome - the delivery was so speedy. If I ever need parts for older appliances that I cannot find at a hardware store, I will most definitely order from you guys.
I unscrewed the backside top part of the dryer with a 5/16 nut driver then, removed the damaged timer assuring I marked the wires harness correctly with the new timer. I removed the damaged timer and inserted the new timer I then replaced and screwed in the backside top of the dryer. The Lint Filter with frame removed without difficulty (without any tools) and, I installed the new Lint Filter with frame with no trouble. The Job was completed in less then 12 minutes.
I removed 2 screws to remove the top control panel the 5 sheet metal screws to remove the back of panel to expose to timer control switch unpluging the power leads to replace the switch' the repair saved me about $ 400.00. My wife had me looking at replacing the Dryer.
Removed the screws from the back of the control panel. Unplugged the old timer assembly and the timer knob. Plugged in the new timer assembly and put the timer knob on. Put the back panel back on and screwed it back on. Very simple. The dryer now works like new. It has instant heat right away and everytime it used. The selector knob was also installed by just slidding it on. I absolutely love this website...it's save me so much money in having to pay someone else to fix it. :)
After ensuring all 5 temp sensors were not open, replaced the timer assy by removing the back of the control section. ( 5 screws ) . removed both wire connectors and 1 screw. removed the old timer assy and knob. put old knob on new timer, installed into slots, installed screw and replaced wire connectors. replaced back panel and vent hose, applied power. Works like new
removed r hex screws from front panel. took off cove. remove timer and knob. put in new timer. replace panel. replace knob.
Removed timer and put new one in. Perfect! Also replaced belt and it went in perfectly. Vacuumed out the interior too.
Pulled the plug from the wall outlet. Removed back on control panel. Removed switch, installed new switch. Very easy. Also had to replace the knob, as it was cracked where it slides over the stem of the timer.
Long eventful troubleshooting. No success. Read your troubleshooting guide. Showed either high temp. sensor or timer. One person commented go straight to timer. So I did. 2 minuite repair, back in service. Thanks
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.