14 of 28 people found this instruction helpful
Level of DifficultyDifficult
Time to do repair:More than 2 hours
ToolsNutdriver, Screw drivers, Socket set
CustomerJohn from Hollywood, FL
Clothes not drying
Removed 4 #20 torx screws from top of electric control panel.Marked and labeled wires on timer before removing them. Removed nob from front of panel before removing defective timer. Installed new timer and resister using labels to put wires back on correct terminals.Put control panel back together with the 4#20 torx screws. Tested dryer. timer working but clothes taking too long over an hour to dry. Removed back panel finding one heater wire broken.Repaired. Can youtell me where to buy a service book on this dryer?
9 of 21 people found this instruction helpful
Level of DifficultyEasy
Time to do repair:15 - 30 mins
CustomerRichard from Brandon, VT
The problem was a broken wire at the door switch
Take off the front panal. Cut off broken wire at the brake. Put male connector on wire. Then connect it to the terminal. Then put the front panal back on. Then test the dryer.