Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS260538
This white lower spray arm assembly comes with a telescopic wash tower.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
Took lower basket out. Unscrewed lower arm assembly, removes it. Hand screwed it back in. No tools required at all.
Help other customers find the most helpful instructions.
Were these instructions helpful?
First make sure the dishwaher is off and secure to work on: remove the lower basket, turn the broken spray arm assy counter clockwise, it may be tight, but no tool be need it, screw it all way out, remove it and replace it with your new one by turning clockwise,make sure its tight, no tools need it but basket in place and the dishwasher is ready to go
This was one of the easiest fixes i have ever done. All you need is a screwdriver. the hardest part about it was unscrewing the old spray arm. I found it was easiest to break the tabs on the old spray arm and pull out the spray tower, leaving the bottom part in. The bottom is the part to unscrew. I then put the metal end of the screwdriver through the two holes where the tabs were and used the screwdriver as a handle to unscrew it. Once it was taken out, I screwed the new spray arm in - buy hand -. You can feel it lock when it is all the way in.
Easy. I removed the dishwasher and all water from inside. After laying the dishwasher on floor, the valve flapper was installed using a pair of pliers. I then set the unit upright, and removed the rear screen from the inside back of the unit. This part has 4 nut screws, and runs the width of the unit. Under the screen, the Piston and Nut Assembly for Check Value simply unscrewed. When I looked at it, I knew this would do the trick. I simply screwed the new one in, and re-installed the dishwasher. After the first cycle, I smiled thinking of all the $$$ I saved.Parts Select is great :)
I tried to take it apart, clean it an put it back together. In the process I found the valve flapper to be old and in need of replacement and the lower spray arm assembl tabs broke and required replacement of the entire assembly when I only needed the bottom half. I cleaned all hose/wet connections, coated with plumbers grease and put back together. No leaks, drains properly. Took a bit more time than expected due to door within pump housing that was removed for cleaning that didn't want to be put back on.
Looked up Model number on site, checked "symptoms", and 64% of the time it was the Piston & Nut Assembly, which was correct. While I had it apart, I replaced Filter Gasket that was deteriorating, and lower spary arm that had a crack. Very easy fix.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.