260202-1-S-GE-WD21X10155        -TIMER
260202-1-S-GE-WD21X10155        -TIMER 260202-2-S-GE-WD21X10155        -TIMER 260202-3-S-GE-WD21X10155        -TIMER

TIMER

PartSelect Number PS260202

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Not draining.
  • Will not fill with water.
  • Compare At

    $87.68
  • You Save

    $14.61
  • Your Price

    $73.07
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 3 reviews What's this?
1-3 of 3
 

5 of 9 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsPliers, Screw drivers, Socket set

CustomerJay from North Liberty IA

Water would not drain.

The washer ran through a full cycle, but the water didn't drain out. I pulled out the drain vent and checked for foreign objects. Also checked at the drain hose/disposal joint and there was no blockage. After removing the bottom panels I noticed the solenoid was shot. Cylinder was burnt up and stuck solid in the up position. I went online and found that a main cause of this can be from the timer causing the solenoid to over exert and burn out. I decided if I was going to order parts and dig into a repair I should replace both. For the timer it is just a matter of unscrewing the inner door panel and unplugging the old timer. Then inserting new one. Couple of things I ran into were the door is no longer heavy enough to stay down so I grabbed a waffle iron as a weight to hold it down. Also will need to unscrew the set screw on the Door lock latch's bottom side. Pay close attention to how it was together helps. For the solenoid I removed the main screws holding the unit in place as well as the c-clip holding the plastic arm. Undo the spring and plug and the whole unit comes out. Reverse these steps with the new solenoid to install.

Help other customers find the most helpful instructions.

Were these instructions helpful?

4 of 7 people found this instruction helpful

Parts Used

  • TIMER

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

Customerchad from springfield IL

Dishwasher would not shut down, it stayed on first cycle

First I turned off the breaker so all the power was off to the dishwasher. Then I removed the door handle, which has one screw on the bottom side. Next i pulled the timers handle off, just pull it straight out. Next i opened the door on the dishwasher and removed the 8 screws on the back of the door. Next i pulled the door panel apart to get to the timer. I disconnected the three plugs from the old timer, then unsrewed the two screws holding the old timer in place. Put the new timer in, and put it all back together. The new timer works great and it solved the problem

Help other customers find the most helpful instructions.

Were these instructions helpful?

2 of 5 people found this instruction helpful

Parts Used

  • TIMER

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerJohn from Drums PA

Water not draining

Simply remove the kick plate locate the water drain selonoid. Took two screws out and one spring off.

So easy. Glad I did not hire a plumber.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3