Quick Question!

Have you ever purchased from PartSelect.com before?

259193-1-S-GE-WD12X378          -Grader Nut
259193-1-S-GE-WD12X378          -Grader Nut 259193-2-S-GE-WD12X378          -Grader Nut http://www.partselect.com/Schematics/GE/00107223i03.gif

Grader Nut

PartSelect Number PS259193

This part works with the following brands: General Electric, Hotpoint, Kenmore.

This part works with the following products: Dishwasher.

Compare At


You Save


Your Price

Get this part fast. Average delivery time via standard shipping: 1.8 days.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Impeller and Seal Kit

Part Number 259598

The impeller and seal kit is used in a dishwasher. The kit includes all the parts needed to do this repair, including the impeller, seal, blade, filter, skidder and skidder holder. If your washer is leaking, not cleaning dishes properly, or not draining, then replacing some parts in the pump can help solve the issues mentioned. The tools needed for this installation project are: 5/16 nut driver, 1/4 inch nut driver, flat-blade screwdriver, Phillips screwdriver, and pliers. Refer to the manual provided by the manufacturer for installation instructions and accurate guidance. Remember to unplug your dishwasher from the power source and wear work gloves as a safety precaution.

In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.8 / 5.0, 1 reviews What's this?
1-1 of 1

5 of 7 people found this instruction helpful

Parts Used:
Level of Difficulty: Really Easy
Time to do repair: 30 - 60 mins
Tools: Pliers, Screw drivers, Socket set
Customer: Gerald from Pinehurst, NC

Leaking seal at solenoid shaft

I disconnected the electrical wires. Then disconnected the support strut and the two hose clamps. I was then able to remove the motor /pump assy where I completed the disassembly of the solenoid linkage and pump assy. I removed the solenoid shaft seal. I disassembled the impella parts & the motor shaft seal. I reassembled using new seals, impeller, and grader nut. The only tricky step was waking up to the fact of a left handed thread on the grader nut. I re-installed the motor/pump unit, tightened the hose clamps, connected the electrical wires, & support strut.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-1 of 1