23 of 31 people found this instruction helpful
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers, Socket set, Wrench (Adjustable)
Customer: Ashraf from Merrick, NY
Leak from the bottom center
The connector pump had a pinhole leak at the seam (new part did not have seams). Also replaced the sump inlet which looked worn and the impeller.
Lay dishwasher on it's back to access the bottom. Loosen all clamps. Remove both U shaped holders on the sump inlet. Remove screws holding the drain motor. Pull out the pump motor and sump inlet. Connector pump can be unscrewed from the bottom.
Replace parts and reassemble. It isn't that bad once you start disassembly, especially for anyone somewhat handy.
5 of 44 people found this instruction helpful
Level of Difficulty: Really Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers
Customer: Robert from Sacramento, CA
Front gasket leak, jets clogged, keypad shorted out
Based on parts select diagrams, I removed the sprayer arms and replaced them along with new washers/bushings.
I simply pulled the front gasket out
15 of 131 people found this instruction helpful
Level of Difficulty: Easy
Time to do repair: More than 2 hours
Tools: Screw drivers
Customer: Mark from Omaha, NE
Control module went out - causing the heating element to super heat, melting several of the plastic interior parts
I replaced the control module, and effected plastic interior parts - tested wihout heat, then re-tested with heat dry - performed beautifully. This is a pretty expensive unit that would cost around $1500 to replace new. And, Sears wanted $1500 to repair, so I saved a bunch doing it myself for about $350.