258123-1-M-GE-WD01X10107-Lower-Spray-Arm-Bearing.jpg
258123-1-S-GE-WD01X10107-Lower-Spray-Arm-Bearing.jpg

Lower Spray Arm Bearing

PartSelect Number PS258123

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Not cleaning properly.
  • Unusual Noise.
  • Compare At

    $2.68
  • You Save

    $.45
  • Your Price

    $2.23
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Related Parts Additional or alternate parts to consider.

Part PhotoPart DescriptionPriceAvailability

Fine Filter Hub Nut

Part Number 259078

$3.56
In Stock

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.9 / 5.0, 3 reviews What's this?
1-3 of 3
 

13 of 16 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsNutdriver, Pliers, Screw drivers, Socket set, Wrench(Adjustable)

CustomerAshraf from Merrick NY

Leak from the bottom center

The connector pump had a pinhole leak at the seam (new part did not have seams). Also replaced the sump inlet which looked worn and the impeller.

Lay dishwasher on it's back to access the bottom. Loosen all clamps. Remove both U shaped holders on the sump inlet. Remove screws holding the drain motor. Pull out the pump motor and sump inlet. Connector pump can be unscrewed from the bottom.

Replace parts and reassemble. It isn't that bad once you start disassembly, especially for anyone somewhat handy.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 35 people found this instruction helpful

Parts Used

Level of DifficultyReally easy

Time to do repair:Less than 15 mins

ToolsNutdriver, Screw drivers

CustomerRobert from Sacramento CA

Front gasket leak, jets clogged, keypad shorted out

Based on parts select diagrams, I removed the sprayer arms and replaced them along with new washers/bushings.
I simply pulled the front gasket out

Help other customers find the most helpful instructions.

Were these instructions helpful?

9 of 76 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:More than 2 hours

ToolsScrew drivers

CustomerMark from Omaha NE

Control module went out - causing the heating element to super heat, melting several of the plastic interior parts

I replaced the control module, and effected plastic interior parts - tested wihout heat, then re-tested with heat dry - performed beautifully. This is a pretty expensive unit that would cost around $1500 to replace new. And, Sears wanted $1500 to repair, so I saved a bunch doing it myself for about $350.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3