Quick Question!

Have you ever purchased from PartSelect.com before?

247776-1-S-GE-WB36X951          -Light Bulb and Socket
247776-1-S-GE-WB36X951          -Light Bulb and Socket http://www.partselect.com/Schematics/GE/00109918i01.gif

Light Bulb and Socket

PartSelect Number PS247776

This light bulb is sold with the socket. The bulb is 120V and 25W.

This part works with the following brands: GE, Hotpoint & Kenmore.

Compare At

$12.88

You Save

$2.15

Your Price

$10.73
Order within the next 7 hrs and your part ships today!
Get this part fast. Average delivery time via standard shipping: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 4.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

65 of 80 people found this instruction helpful

Parts Used:
  • Light Bulb and Socket
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Screw drivers
Customer: Rudy from Huntington, IN

Original lamp burned out.

After looking up on the computer a schematic of the unit, all that was needed was removing four screws to remove the top and side cover which was one piece.
Next was removal of electrical connection to burned out lamp, then removing burned out lamp and installing the new lamp and reconnecting electrical connection.
Job was complete after reinstalling the cover.

Microwave now working with new lamp lighting when in use.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 1 people found this instruction helpful

Parts Used:
  • Light Bulb and Socket
Level of Difficulty: Very Easy
Time to do repair: Less than 15 mins
Tools:
Customer: Jerry from CRAWFORDVILLE, FL

Light burned out

I happen to have a set of "security" screw driver tips which are required for this appliance - available for about $10 at Home Depot or Harbor Freight. Remove three security screws from back of housing, lift up and aft to remove the cover. The light is on the left in a "snap in" mounting so use a flat blade screw driver to push back the retainer and lift out the old bulb then disconnect the two "push on" wires and install the new light. Total time about 10 minutes. The only issue is the requirement for a security driver set.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2