Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS244800
This 6 inch chrome drip bowl is intended for use with solid terminal plug-in style surface burner units on electric ranges.
This part works with the following brands: GE, Hotpoint & Kenmore.
This 8 inch chrome drip bowl is intended for use with solid terminal plug-in style surface burner units on electric ranges.
Unpluged range. Removed back cover to access the infinite switches . removed old burner and drip pan. removed terminal block and retaining screw on cooktop. removed terminal block wiring from infinite switch taking care to mind were the wires came from. Install new terminal block and reattached to cooktop . installed new 8" burner and drip pan reinstalled back panel and plug in electrical to unit . tested burner . replaced stove after verifying burner worked
Help other customers find the most helpful instructions.
Were these instructions helpful?
There was nothing to it...I unplugged the Sufrace Elements from thier bases, removed the Drip Bowls, replaced the Drip Bowls and then plugged the Surface Elements back in to thier bases. The entire process could not have taken more than two minutes.
I lifted out the burners and took out the old drip pans ans then replaced the burners. However the 8 inch pans were bigger than the old ones and they do not fit properly. They are sitting on top of the stove and not inserted like they should be. I will have to look elsewhere to find ones that fit.
Unplug coil, remove pan - place new pan, plug in new element and bingo. Took approximately 30 seconds!
removed burnt out terminal block, installed new- I soldered wires instead of using wire nuts, took a little extra time, but I feel it's a better connection. I later found that my rotary control must have burnt out too, I swapped it with one from another burner. I'll be ordering a couple rotary controls next from this company. All parts were nice quality. Received quickly.
I loosened two screws that held the baking element to the stove and pulled out. Then, with a screwdriver , I took the old wires off and replaced them onto the new Baking Element and reassembled.It was a very easy task and while I was at it,I replaced the Drip Bowl pans on the top of the stove with Chrome ones.I ordered the parts on a Tuesday and, to my surprise, I received them on Thursday, and the cost was about half of what it would have cost me elsewhere (to include GE Parts Warehouse)I highly recommend partselect to all of you that need inexpensive repairs.
Removed burner trays, pulled out heater unit, cleaned up inside of area around all four burners, slipped the burner trays back in and pushed the heater unit back into place.
just put in the new part
unplugged the element took the old pan out and put the new one in, plugged the element back in.
We tried to find the replacement pans at the local hardware store and were disappointed in that although they were cheaper, they were not deep enough to handle the heating elements. We were delighted to find that the parts from PartSelect.Com were genuine GE parts... installed in minutes and were delivered VERY quickly!
I am not going into a description. It is a very minor thing to do. I did appreciate the quick delivery of the parts and will purchase future appliance parts from you again.
I removed the old drip pans, cleaned the range top, washed and installed the new drip pans and put the old pans, box and packing materials in the trash. In only 12 minutes my range top looked like new and the mess was picked up. Now, if I could just get the rest of the kitchen looking that good that fast!
Just removed the elements and inserted the new drip pans. Could not have been easier.
They fit perfect
Just pull out the heat element, place the new drip bowls and then insert again the heat element.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.