Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS244395
This drip bowl is sold individually. It is chrome in color and measures 10 inches in diameter at the widest point, with a hole in the middle. This is used to catch drippings and food that falls when cooking on the oven element. These might burn, become rusty, and wear down over time, and will need to be replaced. Replacing the drip pan is very easy. The elements on the oven must be removed to access the pan underneath. When placing the new bowl, make sure to line up the hole with the terminal block where the element plugs into.
This part works with the following brands: GE, Hotpoint & Kenmore.
The dishwasher roller assembly attaches to the dishrack located in the upper level of the dishwasher. It allows the dishrack to slide and roll easily. If the upper rack keeps falling off the track in dishwasher, the door will not close, the door makes noises, and/ or dishes are not cleaning properly, then it is best to replace it for more security. A flat-blade screwdriver is the only tool needed for this installation. Slide open the upper dishwasher rack and remove retaining tab from both ends of the rack and slide it out. Locate the older roll assembly, remove it, and replace the rollers. Remember to put back the tabs on each side before sliding it back in. Make sure the dishwasher is off before starting this installation project.
1) Make sure unit switches are turned off. 2) Lift Calrod unit up and pull it from electrical receptacle. 3) Withdraw Calrod unit from old bowl. 4) Insert Calrod unit through large hole in new bowl. 5) Push Calrod electrical connectors into receptacle under range top. 6) Seat Calrod unit on bowl rim and insert the assembled Calrod unit and bowl into the hole in the range top.
Help other customers find the most helpful instructions.
Were these instructions helpful?
Removed the old burner bowls, replacing them with the new ones.
I was very excited to get them in the mail but waited to install after a clean up but when I finally opened the box I found I only ordered 1 6 inch drip bowl. lol Now that I know they fit when I reorder I am ordering a who new set for later use.
pull out, push in
I removed the drip bowls and pulled out each coil from the plug on the range. Plugged in the new coils and replaced the drip bowls.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.