| |
1 of 1 people found this instruction helpful
Parts Used
-
- Surface Burner - 8" - 2100W
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerChristine from Danbury NC
Old unit was bent and didn't work properly
I unplugged the old unit and plugged in the new one! It works.
|
1 of 1 people found this instruction helpful
Parts Used
-
- Surface Burner - 8" - 2100W
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsNutdriver
CustomerCharles from Carthage NY
Large burner would not heat
I ordered the wrong part to start with. (READ CAREFULLY!) I reordered the correct part and it was simple. I unpluged the old element, plugged in the new one replaced the drip pan and trim ring and we were back cooking.
Service was fast, lady I spoke with on the phone to exchange parts was knowegable and nice. Great people to deal with.
|
5 of 14 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:30 - 60 mins
ToolsNutdriver, Pliers, Screw drivers
CustomerGregory from Princeton Junction NJ
Control switch did not function and one burner worked only occasionally
First, I used the PatrSelect website, which has great prices, and has helpful diagrams. Once I had all the parts, I worked with my wife to turn off the power at our home junction box. Next, I lifted off the cover over the control area of this range. I removed four nuts to lift out the panel that holds the four controls and the fan switch. I removed the wires from the broken controls, removed the two screws holding each control in place, then screwed the new ones in place. I would recommend trimming the posts on the controls to the correct size before screwing them in place, because it is easier to grip them and not bend them when they are not mounted. I reconnected the wires and replaced the panel. For the "receptacle", I followed the instructions provided regarding cutting the wire and placing the wire nut and heat shrink tubing. I opened the unit that houses the burners to get easy access.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsScrew drivers
CustomerTim from Coeur D Alene ID
No heat
Unplugged unit. Pulled 2 screws from bake element. Pulled terminals and screwed back in. On upper element you just pull the old one and push in the new.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerJose from The Woodlands TX
Coils with tips damaged
it was very easy, a few seconds and new range for a cuople of years more!
|
0 of 3 people found this instruction helpful
Parts Used
-
- Surface Burner - 8" - 2100W
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerManuel from Quakertown PA
The heating element's contacts were burnout
QUITE SIMPLE, JUST PLUG-IN THE NEW ONE
|