Quick Question!

Have you ever purchased from PartSelect.com before?

http://www.partselect.com/Schematics/GE/00115502i01.gif
See part 58 in the diagram
http://www.partselect.com/Schematics/GE/00115502i01.gif

Dual Haliant Element

PartSelect Number PS243917

You can adjust the size of the burner you want to use to match your pots/pans.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Element will not heat.

Compare At

$113.65

You Save

$18.94

Your Price

$94.71
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.3 / 5.0, 2 reviews What's this?
1-2 of 2
 

1 of 3 people found this instruction helpful

Parts Used:
  • Dual Haliant Element
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver
Customer: joy from st. augustine, FL

Middle burner not working

Use a 1/4" nutdriver and remove the screws that are on the bottom corners of the range top.Prop up the range top high enough for ease of using 1/4" nut driver. Take a picture of the wiring for future reference on re-installing wiring. Note arrow location on burner and remove 1/4" screws holding the clamps to the burner in place and place to the side for re-install on new burner.Remove wiring off old burner.Hold new burner in place with arrow location in previous location and notice holes where clamps will go. Screw clamps on burner using original screws and snap in mounting slots on stove.Re-install wiring.Lower range top and re install 2 screws , 1 in each corner under range top. Test for proper operation and enjoy!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1 of 3 people found this instruction helpful

Parts Used:
  • Dual Haliant Element
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Screw drivers
Customer: Ernest from Charlestown, NH

Burner didnt heat

The unit has two spring clips that hold it in place. Also two screws that hold the element to the clips. It comes apart ok but doesn't go back as easy. I didn't remove the top as there was room to work from under it.

My daughter held the top down against a wooden dowl i was using as a prop rod . My wife held the unit in place . I finally got the clips back on and the screws back in . Centered the unit , transfered the wires , and it works perfect . Only three people and 30 min.

Thank you PartSelect for all your help !!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2