Quick Question!

Have you ever purchased from PartSelect.com before?

243903-2-S-GE-WB30T10045        -Large Haliant Burner with Limiter - 8"
243903-2-S-GE-WB30T10045        -Large Haliant Burner with Limiter - 8" 243903-1-S-GE-WB30T10045        -Large Haliant Burner with Limiter - 8" http://www.partselect.com/Schematics/GE/00116954i02.gif

Large Haliant Burner with Limiter - 8"

PartSelect Number PS243903

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Element will not heat.

Compare At

$110.06

You Save

$18.34

Your Price

$91.72
Order within the next 11 hrs and your part ships today!
Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.6 / 5.0, 3 reviews What's this?
1-3 of 3
 

51 of 64 people found this instruction helpful

Parts Used:
  • Large Haliant Burner with Limiter - 8"
Level of Difficulty: Easy
Time to do repair: Less than 15 mins
Tools: Nutdriver, Screw drivers
Customer: Kevin from Leominster, MA

Large burner would not get hot

Repair was very simple. Removed 2 screws under the cooktop, tilt the cooktop back, unplug 4 wires from 8" burner, remove two screws holding retaining clips, install new burner in reverse order. Very simple!

Help other customers find the most helpful instructions.

Were these instructions helpful?   

13 of 19 people found this instruction helpful

Parts Used:
  • Large Haliant Burner with Limiter - 8"
Level of Difficulty: Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: John from Hopewell Junction, NY

Left rear element would not get hot.

FIRST TURN OFF THE CIRCUIT BREAKERS THAT POWER THE COOKTOP!! Remove the cooktop from the counter by removing the screws from the mounting straps under the counter. Then remove the screws that hold the glass cooktop to the frame and lift off the glass top. Next lift up the bad element and unplug one wire from the bad element and plug it into the new element. Make sure to put it on the exact same terminal of the new element. Do this for all the wires. Remove the two mounting tabs from the old element and put them on the new element. Turn on circuit breakers and your done.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

13 of 21 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 30 - 60 mins
Tools: Nutdriver, Pliers, Screw drivers
Customer: Cheryl from Sequim, WA

Burner "burned out" so we replaced the one and replaced the other that seemed to be cooling down.

Basically removed the screws holding the op on and removed the vent from back. Just "figured it out" and now it works. Wish I could be more helpful. Recommend moderate experience and confidence.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-3 of 3