http://www.partselect.com/Schematics/GE/GE_Thumb/00003136i02.gif
See part 51 in the diagram

CLAMP

PartSelect Number PS241928

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $7.94
  • You Save

    $1.32
  • Your Price

    $6.62
Special Order
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 2.3 / 5.0, 1 reviews What's this?
1-1 of 1
 

1 of 2 people found this instruction helpful

Parts Used

Level of DifficultyA Bit Difficult

Time to do repair:1- 2 hours

ToolsPliers, Screw drivers

CustomerDonald from Friendswood TX

Connect the exhaust and wiring to the cook top

The new cook top required more room below to accommodate the exhaust fan.

First I removed the cabinet shelf that was in the way, using a saw and hammer.

Second, I tried to locate the transition exhaust part but could not identify the part until I found Partselect.com on the net. They had the diagrams showing the parts and placing the order with them was a snap.

Third, the transition exhaust was taped in position with aluminum tape.

fourth, I connected the wiring, with the electricity shut off at the breaker panel, as indicated on the placard attached to the cook top.

Fifth, and most difficult was running the 6 inch diamater exhaust duct to the outside vent. The vent was buried in the far back corner of the cabinets. The duct I used is aluminum and extends out to 8 feet in length. The metal tape was used to connect it to the transition exhaust.

It was a straight forward job with no real problems other than working in close quarters.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-1 of 1