239341-1-S-GE-WB27X10215        -Electronic Range Control
239341-1-S-GE-WB27X10215        -Electronic Range Control 239341-2-S-GE-WB27X10215        -Electronic Range Control 239341-3-S-GE-WB27X10215        -Electronic Range Control

Electronic Range Control

PartSelect Number PS239341

***NOTE: The wiring could be different on this part than on the original. This part should be installed by an appliance repair person.

This part works with the following brands: GE, Hotpoint & Kenmore.

  • Compare At

    $210.14
  • You Save

    $35.02
  • Your Price

    $175.12
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

4 of 5 people found this instruction helpful

Parts Used

  • Electronic Range Control

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerChris from Valdosta GA

Ranges and oven wouldn't work

I turned the power off to the stove. I removed the 4 screws from the back. I took the 2 screws out of the old control to8 to give me a reference for the wires. I then disconnected each wire from the old part and directly to the new part. I then turned the power on before I put the stove back, and as I flipped the breaker, my wife yelled at me that she just saw fire come out of the back. I thought that was interesting because there just went $105 up in smoke. I turned the power off and went to look at the damage. After searching over all the parts and not finding any burnt areas, I had my wife turn on the power while I looked for the problem. I located the problem at the power box where the stove is connected to the wall. When I pulled the stove out it pulled one of the wires out of the wire nut and caused it to hit the metal box and when the power came back on, it melted the wire nut because of the loose wire. I replaced the wire nut and reconnected the wires securely and tried turning the power on again, and the part worked just like new. Be careful not to pull loose any wires.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1 of 6 people found this instruction helpful

Parts Used

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerBlair from Webster FL

Replace bake element and range control

The bake element was very easy especially since I had the back off to replace the control. The only problem I had with the control was removing the face plate from the old control to use on the new one. I used a heat gun to help soften the glue and then was able to remove it. The wiring was a little differant on the new contrl, but the instructions that came with the new control were very good. Everything is working fine. Thank you for your good service. Blair W

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2