238574-1-S-GE-WB27T10276        -Electronic Clock Control
238574-1-S-GE-WB27T10276        -Electronic Clock Control 238574-2-S-GE-WB27T10276        -Electronic Clock Control 238574-3-S-GE-WB27T10276        -Electronic Clock Control

Electronic Clock Control

PartSelect Number PS238574

*Wiring could be different from original and will possibly need to be installed by an appliance repairperson.

This part works with the following brands: GE, Hotpoint & Kenmore.

This part fixes the following symptoms:

  • Will not program.
  • Compare At

    $277.03
  • You Save

    $46.17
  • Your Price

    $230.86
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.4 / 5.0, 3 reviews What's this?
1-3 of 3
 

29 of 36 people found this instruction helpful

Parts Used

  • Electronic Clock Control

Level of DifficultyA Bit Difficult

Time to do repair:30 - 60 mins

ToolsScrew drivers

CustomerTravis from Thomasville NC

Oven used broiler element not bake to maintain temp

Pulled Circuit Breaker to turn off power to oven

Removed oven door just to get it out of way

Removed top panel by removing two screws on
underneath panel left and right

Panel must be lifted to releace from two guide pins
At top, I used towel protect panel and layed panel
down flat.

I drew picture of old ERC and labeled where each
Wire went and what color it was.

I removed old ERC by removing four screws and
placed it next to new ERC.

I made drawing of new ERC-3 and decided where
each wire would go.

The replacement instruction apeared difficult to me the first time I read them, but after finding the
Small stamped letters on the broil and bake controls on the ERC it became fairly easy.

There are more connections on the new ERC
Than I needed for my Installation. I installed the
New ERC and everything worked fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

9 of 13 people found this instruction helpful

Parts Used

  • Electronic Clock Control

Level of DifficultyEasy

Time to do repair:30 - 60 mins

ToolsNutdriver, Pliers, Screw drivers

CustomerLarry from Oxford OH

Broiler was staying on

Removed oven unit from wall. Removed top and back cover. Disconnect the wires from clock control marking them with tape and making a drawing of where the wires are. The back of the replacement control was a little different.The new controller had a place for a convection control which I didn't need. It went pretty well. If your an average repair person. You will have no problem.

Ps, On the old control you can remove the big black caps and look at the coil. Thats when I seen it was bad.

Help other customers find the most helpful instructions.

Were these instructions helpful?

5 of 6 people found this instruction helpful

Parts Used

  • Electronic Clock Control

Level of DifficultyReally easy

Time to do repair:15 - 30 mins

ToolsScrew drivers

CustomerMichael from Lafayette CA

Control failed, no upper oven operation.

Six screws remove the oven control assembly cover. Four screws remove the control from the cover. A few spade connections to swap to the new unit. And reassemble. Power off during repair, of course. This is control number three. Typical GE quality.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-3 of 3