Quick Question!

Have you ever purchased from PartSelect.com before?

238571-1-S-GE-WB27T10272        -Electronic Clock Control with Door Latch
238571-1-S-GE-WB27T10272        -Electronic Clock Control with Door Latch 238571-2-S-GE-WB27T10272        -Electronic Clock Control with Door Latch 238571-3-S-GE-WB27T10272        -Electronic Clock Control with Door Latch http://www.partselect.com/Schematics/GE/00011879i01.gif

Electronic Clock Control with Door Latch

PartSelect Number PS238571

This part may look different from the original, but should still function the same. The wiring is different, and is recommended to be installed by a repair person.

This part works with the following brands: GE, Hotpoint & Kenmore.

Compare At

$252.60

You Save

$42.10

Your Price

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

4 of 6 people found this instruction helpful

Parts Used:
  • Electronic Clock Control with Door Latch
Level of Difficulty: Really Easy
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Screw drivers
Customer: Robbie from Lena, MS

Nothing would work but the oven light when you opened the door.

From beginning to end, it was simple. First, as always, I turned 'OFF' the power. I've been an electrician for about 35 yrs., but any one could have fixed this. I just placed the new product in front of the old one and transferred the wire connections. Then I removed the old unit and attached the new one, closed the door, turned the power on, and "We Cooking Now". Thanks for fast delivery of the ordered product. Robbie

Help other customers find the most helpful instructions.

Were these instructions helpful?   

4 of 12 people found this instruction helpful

Parts Used:
Level of Difficulty: A Bit Difficult
Time to do repair: 15 - 30 mins
Tools: Nutdriver, Pliers, Screw drivers
Customer: Stephen from West Caldwell, NJ

F0 error message - oven won't heat

Removed front display panel by removing 3 screws with nut driver. Removed ERC control board from display panel by removing 2 screws. Labeled all wires according to the terminal description on the existing board (this is important as the new control board terminations are in different places than the existing one. Disconnected wires. Removed keying sleeve from 2 wires since the new control unit was keyed differently. Connected wires to the new control board. Re assembled board to display panel and panel to oven. Works great.

Help other customers find the most helpful instructions.

Were these instructions helpful?   

1-2 of 2