| |
1 of 3 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:30 - 60 mins
ToolsScrew drivers
CustomerKevin from Mukilteo WA
Fountain broken
Fried the new circuit board, dead short somewhere.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
ToolsPliers
CustomerBruce from Clarkridge AR
Clearing an ice jam resulted in a broken ice chute door
This is an easy repair and doesn't take hardly any time, once you can identify the electrical bridals to disconnect and the position of the new ice chute door interface point with the solenoid.
The supplied directions are complete but were quite a bit blurry. The more general dissasembly which is effectively 5 screws and two electrical bridals to remove/disconnect is straight forward. Pay particular attention to the mounting point of the ice door interface with the solenoid. I did it twice because I didn't align the door properly the first time:-)
Much too easy a job than to "call the guy."
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
Tools
Customerrichard from dix hills NY
The flapper for the ice dispensor was broken
i removed the front cover of the dispensor, easily put the parts in and put back together , the first tome the flpapper came off as i did not secure properly but it only took a few minutes to resecure and now working fine .
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyEasy
Time to do repair:15 - 30 mins
Tools
CustomerPat from Spring TX
The door strike was broken on my dispensor
The repair did not work. The new door strike did not embrace the solenoid.
I had the old spring, and it fit exactly. I also ordered a roll pin, but have no clue as what to do with it. Excellent directions came with the door strike, but nothing with the roll pin.
Was hoping the roll pin would connect the door strike to the solenoid, but did not see how that would work.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsNutdriver
CustomerMerle from Houston TX
Ice maker chute door broke off
Easy to install and it works fine. Recommend using the instruction manual and it was a breeze
|