| |
10 of 13 people found this instruction helpful
Parts Used
Level of DifficultyA Bit Difficult
Time to do repair:15 - 30 mins
ToolsPliers, Screw drivers, Wrench(Adjustable)
CustomerShayne from Angoon AK
Oven was only turning on occaisionally
I took the oven bottom out and then removed the screws that cover the safety valve, then I pulled the oven out and undid the safety valve in the rear of the oven. This was all accomplished with the electricity off and the propane also turned off. I then reinstalled the safety valve.
|
2 of 3 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerCindy from Colton CA
Oven floor panel was warped.
It was so easy, I pushed the panel towards the back and lifted the front up then lifted it right out. I am so glad that you had the part. I ordered it and when it got here, I just sliped it right in, perfect fit! Thank you so much! Cindy Brison
|
1 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:15 - 30 mins
ToolsScrew drivers
Customerbrian from granite falls WA
Oven taking 30 mins to preheat and stinks like gas.
*Oven floor panel was blocked by fan guard.*
Had to remove fan guard first as I have the convection feature. Easy. 6 screws.
Replaced the oven floor panel, stained and warped.
Checked the ignitor switch by trying to preheat oven. Switch heats up but not enough to ignite gas.
Replaced the Ignitor. Easy. Plug and Play. Replacement insulation comes with the ignitor.
Thank You Parts Select. Youre my new favorite website. I can't wait until my next appliance breaks down.
|
1 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerJoel from Monroe NY
Floor panel heavily stained and warped
slide latches in rear of floor panel forward and remove.
|
0 of 1 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerSteve from Tyngsboro MA
Oven not evenly cooking food
If your food is not cooking evenly, a warped floor panel with attached difuser (or "v" shaped heat shield) may be the cause. Simply slide the 2 clips to unlock the panel and move the entire assembly up-and-out (back first) and slide the new one in. Be sure the clips are lined-up with the holes in the back of the oven. The new floor panel comes with the new heat shield.
|
0 of 2 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
ToolsScrew drivers
CustomerLinda from Staten Island NY
Replacing warped oven floor panel
Very simple and stressfree - popped out old - popped in new.
|
0 of 4 people found this instruction helpful
Parts Used
Level of DifficultyReally easy
Time to do repair:Less than 15 mins
Tools
CustomerRoger from San Juan Capistrano CA
The floor panel of the oven was pocked and in bad shape
I found the panel on the innernet, ordered it and when it arrived I removed the old one and replaced it with the new one.
|