http://www.partselect.com/Schematics/Frigidaire/Frigidaire_Thumb/OF2DGSX9.gif
See part 97 in the diagram

Electronic Control Board

PartSelect Number PS2373490

This part works with the following brands: Frigidaire, Gibson, Kelvinator, Kenmore, Tappan & White-Westinghouse.

  • Compare At

    $276.13
  • You Save

    $46.02
  • Your Price

    $230.11
In Stock
Fast Shipping Get this part fast. Average delivery time via regular ground: 1.8 days.

Installation Instructions Provided by PartSelect customers like you.

Average Repair Rating: 3.9 / 5.0, 2 reviews What's this?
1-2 of 2
 

6 of 10 people found this instruction helpful

Parts Used

  • Electronic Control Board

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Pliers

CustomerArman from Bloomington IN

Board malfunction: Burner will not shut off.

Shut off the circuit breaker. Unplug the power cord. Remove the back panel or have it lean open against the counter. The board is located in the bottom left hand corner. Remove the white color board connections by grabbing the sides and gently rocking them out. Leave all the wire connections on the right hand side in place for now. Remove the board screws. There are 4 white snap on board holders. Squeeze the middle of the holder to release using thin nose pliers. Your finger nail may work here as well. Once the board is loose (keep the wires attached) remove the screw spacers from the back of the board and attach them to the new one in the same place. They should easily snap off but will not easily snap on. Squeeze the tip to push them in. Snap the board in place in over the holders and secure the board with the screws. Do not over tight. Match the holes with the white board connections and slide then in place. The old board is still hanging on the side connected to the wires. From the top remove each wire by rocking it out and place it in the same location on the new board. Don’t push too hard it may bend the connection flap or break it. When all the connections are complete the old board is free. Replace the back panel. Plug the stove in. Get the breacker. Keep fingers crossed. And test the burners.

Help other customers find the most helpful instructions.

Were these instructions helpful?

6 of 10 people found this instruction helpful

Parts Used

  • Electronic Control Board

Level of DifficultyEasy

Time to do repair:15 - 30 mins

ToolsNutdriver, Screw drivers

CustomerSaverio from Howell NJ

One of the heating elements would operate intermitantly.

I removed the 10 or so screws that held the rear
cover in place. then I removed the power board,
and replace it with the new power board.
Now everthing works fine.

Help other customers find the most helpful instructions.

Were these instructions helpful?

1-2 of 2