Have you ever purchased from PartSelect.com before?
Thank you for helping make our site better.
PartSelect Number PS2370502
The rack slide end cap is the part that attaches to the rails of your upper dish rack and prevents the dishrack from sliding too far. If you find the dish rack is causing the door to not close properly, it may be due to the part being worn-out or damaged and in need of being replaced. All you will require is a small flat blade screw driver for this easy repair. You simply pop out the cap and snap the new one into place. If the rear cap needs to be replaced you will need to remove both front caps and slide the rack completely off for full access.
This part works with the following brands: GE, Hotpoint & Kenmore.
This part fixes the following symptoms:
You need to carefully take off the end caps (which I broke), pull off the rack rollers/ snap the new rack rollers on, and carefully place the end caps back on.
Help other customers find the most helpful instructions.
Were these instructions helpful?
The end cap snapped into place perfectly without any problems and the rack works like new again. This is the second time I have used PartSelect.com and I am very satisfied with how fast I recieve the product and the easy of finding what I need. I would recommend them to anyone!
Removed the broken items and clicked the new ones in place utilizing a pliers
Super easy..........just push it on and it should snap in place. No tools required!
I installed the roller wheels on the lower rack and the wheels and end cap on the upper rack and the shelves looked like new after I was finished.
I had put up with this for over year- I disconnected what was left of the damaged front rollers. Snapped into place the two new rollers at the front, and the missing end cap. NO MORE BROKEN DISHES!!
I used needle nose pliers. I bent the stainless steel guide arm out so that I could insert the end cap. Once the end cap was installed I used the same needle nose pliers to "pinch" the guide arm back tight around the end cap. The end cap had premanufactured "notches" to hold the end cap in place once the guide arms are pinched down.
All brand logos are trademarks of their respective owners.
The PartSelect logo is a Registered Trademark of Atlantic Laundry Centres, Ltd.
Copyright © 1999-2017 , Eldis Group Partnership. All rights reserved.